Humidification & Nebulization

The Curaplex® High-Flow Bubble Humidifier features a 360° molded, low resistance, high output diffuser head design. The special diffuser and relief valve are designed to deliver high flows with minimum internal resistance. A pressure relief valve automatically resets and features an audible alert. It is marked in large print to indicate minimum and maximum water levels. The humidifier is designed with an easy seal, translucent, double helix thread jar and the domed lid is two-toned beige and black. Features: * 360° molded, low resistance, high output diffuser head design * Special diffuser and relief valve design delivers high flows with minimum internal resistance * Pressure relief valve that automatically resets * Audible pressure relief alert * Jar permanently marked in large print, minimum/maximum water levels * Easy seal, translucent, double helix thread jar * Domed lid is two tone beige and black Specifications: * High-flow * 6 PSI * Up to 15LPM * 350cc * Dry

The Curaplex® Nebulizer and Humidifier Heaters are capable of higher patient-end temperatures and are recommended for use with high flow applications. Features: * For use with Curaplex Nebulizers or Heaters * Power supply: 115 volts California Proposition 65 Warning: ⚠ WARNING: This product may use 'Clear Vinyl” in the manufacturing process and therefore may contain one or more chemicals on the Prop. 65 chemical list which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.

Bracket for the P2000 heater.

The closed system design of these flexible solution bags helps minimize the possibility of contamination to your patients. When solution bags are attached to the appropriate feed sets, replenishing empty nebulizers and refilling chambers are simplified. The easy one-step set-up offers convenience and reduces patient interruptions. The solution bags contain sterile water for inhalation, USP, and are available in two sizes: 1,000 and 2,000 mL.

These Dry Bubble Humidifiers provides effective and consistent results for your patients across the entire clinical flow range and incorporate unique features to address your everyday requirements. With the included High Flow Comfort Soft Plus™ Cannula, maximum comfort for the patient while virtually eliminating ear ulceration combined with a High Flow Humidifier that vastly reduces splash and residual solution in your oxygen tubing. Flow rates are not compromised by restrictions and resistance caused by excess condensate in the tubing, a common occurrence with industry competition.Features: * Pressure Relief ValveHumidifier Jar Engraved with Minimum/Maximum Water Level PointsUnique Baffling System to Minimize Splash Exiting into the TubeInterfaces with Oxygen Concentrator, Liquid O2 Systems, O2 Tanks and Wall Outlet ApplicationsHome Care, Hospital & Alternate Care Applications Recommended Flow Rates of up to 15 LPM

The High Flow Bubble Humidifier features a 360° molded, low resistance, high output diffuser head design. Its special diffuser and relief valve design delivers high flows with minimum internal resistance. The pressure relief valve automatically resets and features an audible alert. The jar is permanently marked in large print to indicate minimum and maximum water levels. The humidifier is designed with an easy seal, translucent, double helix thread jar and the domed lid is two-toned beige and black. Features: * 360° molded, low resistance, high output diffuser head design * Special diffuser and relief valve design delivers high flows with minimum internal resistance * Pressure relief valve that automatically resets * Audible pressure relief alert * Jar permanently marked in large print, minimum/maximum water levels * Easy seal, translucent, double helix thread jar * Domed lid is two tone beige and black Specifications: * High-flow * 6 PSI * Up to 15LPM * 350cc

Low compliance Single and Dual heated wire breathing systems for Invasive and Non-Invasive therapies, delivering gas at optimal humidity and temperature to patients requiring respiratory support. All Heated Wire Breathing Systems limbs feature a double coiled heated wire configuration providing a consistent warming of gas flow and limb wall minimizing possible rain-out. Features: * Available with multiple components * Sterile packed breathing systems * Double coiled heated wires

These Dry Bubble Humidifiers provides effective and consistent results for your patients across the entire clinical flow range and incorporate unique features to address your everyday requirements. With the included High Flow Comfort Soft Plus™ Cannula, maximum comfort for the patient while virtually eliminating ear ulceration combined with a High Flow Humidifier that vastly reduces splash and residual solution in your oxygen tubing. Flow rates are not compromised by restrictions and resistance caused by excess condensate in the tubing, a common occurrence with industry competition.Features: * Pressure Relief ValveHumidifier Jar Engraved with Minimum/Maximum Water Level PointsUnique Baffling System to Minimize Splash Exiting into the TubeInterfaces with Oxygen Concentrator, Liquid O2 Systems, O2 Tanks and Wall Outlet ApplicationsHome Care, Hospital & Alternate Care Applications Recommended Flow Rates of up to 15 LPM

Kit, Therapy, Oxygen, High Flow

Sterile Water features include: * For Inhalation USP * Universal Pour Bottle

Ster-O2™ Humidifier features include: * Pre-Filled Adapter * 5 PSI Pressure-Relief Valve * Audible Alarm

High Flow Cannula and Humidifier Kit features include: * 360° molded, low resistance, high output diffuser head design * Special diffuser and relief valve design delivers high flows with minimum internal resistance * Pressure relief valve that automatically resets * Audible pressure relief alert * Jar permanently marked in large print, minimum/maximum water levels * Easy seal, translucent, double helix thread jar * Domed lid is two tone beige and black * Enhanced reservoir facepiece * bright green supply tubing * Includes 77-1600HF and 77-7900

The nasal cannulas are available in small, medium, and large. They are rated for up to 80LPM and pair seamlessly with the Bonhawa to create optimal airway pressure. The Telesair® Nasal Cannulas are made for Telesair® and with the highest flow rating to cover higher acuity patients. They are available for pediatric patients (small) as well. Features: * Available in Small, Medium, and Large * Lightweight and high functioning * Pairs seamlessly with the Bonhawa * Flow range from 2-40 LPM for size small and 10-80 LPM for medium to large sizes (*Approved for up to 70 LPM in the USA) Cannula Construction: * 2.2 cm (M) Standard Swivel Connector * Neck Strap * Gas Delivery Conduit * Head Strap * Nasal Prong Interface * Retaining Clip

Hudson AQUAPAK® prefilled humidifiers combine an easy to use adapter with a choice of two sterile water reservoir bottles. The humidifier adapter incorporates an audible alarm that alerts the clinician to flow restriction or occlusion of the humidifier or oxygen tubing. The reservoir bottles have a built-in oxygen tubing connector with an easy snap-off trigger design. A micro-diffuser, molded into the reservoir bottle, produces smaller bubbles and increases surface area agitation allowing for noise-free humidification. Features: * latex-free * gamma sterile * single use * individually packed

The Telesair® Heated Breathing Circuit Pack helps provide continuous humidity to dry gas and maintains heat and humidification of the gas during high flow oxygen therapy. The pack contains a single use intelligent water chamber adapter, a water chamber and a heated breathing circuit. Water Chamber: * Duration of use: 7 Days, Single-Patient * Designed for Pediatric, Adult patients * Fill Water Type: Automatically * Maximum Water Capacity: 150mL * Maximum Peak Flow: 180ml/min * Compatibility: ISO 80601-2-74 Heated Breathing Circuit: * Duration of use: 7 Days, Single-Patient * Designed for Pediatric, Adult patients * Circuit Length: 200 ± 20 cm * Compatibility ISO 5367, ISO 5356, ISO 80601-2-74, IEC 60601-1, IEC 60601-1-2

AQUAPAK® prefilled humidifiers combine an easy-to-use adapter with choice of two sterile water reservoir bottle sizes. The micro-diffuser produces smaller bubbles and greater surface agitation for quiet operation and high humidity output. Humidifier adapters incorporate audible alarm to alert clinician to flow restriction or occlusion of humidifier or tubing. Reservoir bottles have built-in oxygen tubing connectors.

Unit Dose features include: * Saline (0.9% NaCL) * for Inhalation * Graduated Vial

Replacement sterile water and saline for Airlife nebulizers.

AQUAPAK® prefilled humidifiers combine an easy-to-use adapter with choice of two sterile water reservoir bottle sizes. The micro-diffuser produces smaller bubbles and greater surface agitation for quiet operation and high humidity output. Humidifier adapters incorporate audible alarm to alert clinician to flow restriction or occlusion of humidifier or tubing. Reservoir bottles have built-in oxygen tubing connectors.

The Telesair® Bonhawa Humidifier represents the next generation of high flow therapy, engineered around clinician needs with three key innovations: faster disinfection processing time, higher flow up to 70 LPM, and real-time flow monitoring capability through our large front-facing touchscreen. Drive better outcomes with humidification across all flows and quick therapy delivery - no delays, just optimal patient care. Bonhawa Humidifier delivers more time for patient care and less time on device management. Performance: Advanced Respiratory Support When It Matters Most * Extended Flow Range: * Up to 70 LPM to cover broader patient acuity * Real-Time Monitoring: Large forward-facing touchscreen (10.9cm x 6.1 cm / 4.3in x 2.4in) enables monitoring from across the room * Optimal Humidification: Delivers >33 mg/L relative humidity at 37°C setting * Fast Warm-Up: Only 10 minutes to reach 31°C and 34°C, 30 minutes for 37°C * Confirmed Therapy: Real-time changes in device output and status for reduced risk of user error Efficiency: Streamlined Workflow, Reduced Total Cost of Ownership * Quick Disinfection: Up to 90% reduction in disinfection time - simply change disposables and wipe down * Intuitive Operation: 'Touch, Turn, Touch” capability for quick, easy setting changes that can be done with one hand * Patient Turnover: Switch between patients with minimal effort in less than 10 minutes * Innovative Gas Path: located external to the device for quick disinfection and quick turnaround Versatility: Adaptable Solutions for Your Clinical Scenario * Continuous Therapy On-The-Go: Over 90 minutes of battery life when used with the UPS 90 Pure transport battery solution * Maintain Critical Care: Heat and humidity remain active during transport for uninterrupted therapy * Choose from Pediatric & Adult Modes: Flow settings from 2-25 LPM for pediatric patients and 10-70 LPM for adults * Universal Compatibility: Works with any standard 22mm cannula connection, but is optimized when used with Bonhawa cannulas rated for up to 70 LPM of flow

The AQUATHERM® III is an adjustable, external heater electronic heater for thermal humidification (nebulization) to be used with AQUAPAK® Nebulizer systems.

Telesair® Bonhawa High Flow Oxygen Therapy (HFOT) Air Filters. This is an accessory for Bonhawa Humidifier. Required for use to filter intake air. Visually inspect the filter after each patient and replace monthly. Packaged in a box of 30 individually wrapped. Features: * Material: Blended synthetic fiber * Biocompatibility: * ISO 10993-1, 18653-1 * ASTM Spec ASTM D737 * AVG BFE Efficiency: 99.9996% * AVG VFE Efficiency: 99.996% * Air Permeability: >125 CFM

UPS 90 Pure Hospital Transport Battery is an accessory for Bonhawa Humidifier. Features: * Models: HF110UPS90 Pure (Choose options: 100-120V, 220-240V or 90-110V) * Medical Grade: IEC 60601-1, IEC 62133-2, UL94 V0 compliant. * Pure Sine Wave: Compatible most biomedical equipment (i.e. heated humidifiers) * Line-Interactive UPS: Runs the device while charging the battery. Most biomedical devices will not reset with power interruptions (i.e. F&P Airvo2 and Oscillator 3100A). * Integrated Mounting Adapter: Very easy to mount with the standard mounting adapter. (i.e. fits the F&P Airvo 2 cart built-in bracket. (Note: Locking bracket available for a separate purchase.) * Low Battery Alarms: 3-stages at 20%, 10%, and 5% (audibly different). * Digital Battery Capacity Display * Low Battery Warning Lights: Battery power LED light visible from 6 feet away (green >25%, yellow 11% to 25% and red ≤10%). * Unlimited Linking: Can connect batteries in series to get as much run time as needed. * Powers Aerogen Simultaneously: Extra AC outlet and USB-A ports for both types of controllers. * Prevents Unplugging: Secure plugs with locking loops using zip ties. Red reusable zip ties included. * Silent Operation: Solid state cooling with no fan noise and no fan vent opening to trap germs. * Starts F&P Airvo 2 without plugging in the wall * Silicone cover (IP22 rated): Protect from liquid, dust, bumping and dropping damages. * Easy Disinfection: Disinfect with hospital wet wipes. * Maintenance Free: No preventative maintenance needed. Need to plug-in and charge battery when not in use. * Lifespan: 8 years * Warranty: 5 years (on purchases after 1/1/2025. Prior purchases are 2 year warranty) Specifications: * Battery is rechargeable * Digital Display * Weight = 5lbs * Power = 120V or 230V * Dimensions = 11.5in x 6.5in x 2in Device Compatibility: * Supports Telesair Bonhawa High Flow Oxygen Therapy (HFOT) System and other HFNC * 90 min at 37°C and 60/70 LPM * Heaters * 70 min at 37°C and 60 LPM * HFOV Oscillators * 90 min * Blood Gas Analyzers * 2 hours * Air Medical Equipment Backup * Airborne Isolette, Nitric Oxide, Vents, ECMO Pumps, Monitors, etc. * Nebulizer (AC or US B controller)

The Telesair®HFOT Flowmeter, Manifold and Bracket Set-Up is a set designed to be used with the Telesair® Bonhawa Humidifier System. Set Includes: * (1) Quad block with one DISS hand tight O2 connection on top and three diss male one way valves on bottom * (1) 70LPM flowmeter, attached to pole mount * (2) 3ft O2 hoses, diss hand tight on both ends * (1) 9ft O2 hose, diss hand tight on both ends