IV Adjuncts

Curaplex® Pressure Infusers incorporate a gauge with a pressure release at 325 mm/hg. They are single patient use and available as 500mL or 1000mL. Features: * Gauge incorporates a pressure release at 325 mm/hg * Single Patient Use * Disposable

Blood and IV fluid warming set with injection port for HOTLINE fluid warmer.

JELCO® IV Catheter features include:* Radiopaque FEP Polymer* Straight Hub* 22 ga x 1-in

Stopcock features include:* 3-Way* Swivel Male Luer Lock* Lipid Resistant

The Saf-T Wing® Blood Collection & Infusion Set handles delicate venous blood draws, utilizing a safety feature activated with a simple one- or two- handed technique.Features: * Safety feature is activated while the device is in the patient with a simple one- or two-handed technique* Saf-T Holder® comes with the back-end needle and Luer permanently attached to the holder to reduce potential exposures and holder re-use, compliant with OSHA directives. * Clamp minimizes blood leakage from tubing upon disposal

IV connectors and sets that eliminate clamp confusion while helping you improve safety practices and patient care. California Proposition 65 Warning: ⚠ WARNING: These products can expose you to chemicals such as vinyl chloride, ethylene oxide, bisphenol-A (BPA), diisodecyl phthalate (DIDP), and/or di(2-ethylhexyl) phthalate (DEHP) which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov. The above warning is required under California’s Safe Drinking Water and Toxic Enforcement Act of 1986, more commonly known as “Prop 65”. Some ICU products may be sterilized using ethylene oxide and some ICU intravenous tubing and drip chambers are manufactured using polyvinyl chloride (PVC) that may contain vinyl chloride, DIDP and/or DEHP. Also, certain manifold, stopcock, connector, and check valve products are manufactured using polycarbonates that may contain BPA. This shipment may contain one or more of these products.

Saf-T Holder® devices come with the back-end needle and multi-sample Luer permanently attached to the holder to minimize potential exposures and holder re-use. Saf-T Holder® devices also provide easy needless transfer after a syringe draw.Features: * Back-end needle and Luer permanently attached to the holder to assure compliance with OSHA directives. * Provide safe needleless transfer after a syringe draw.

The FEP polymer construction and "J"-point needle design allow clinicians to easily feel the vein entry. Anesthesiologists use JELCO® I.V. Catheters for their ease of use starting arterial lines and gaining I.V. access. The thin wall catheter design provides higher flow rates than standard wall catheters, often allowing for use in a smaller gauge device.

Female Port Cap features include:* IV Accessory* Red

Extension Set features include:* Non-DEHP Formulation* Latex-Free* Lipid Resistant* Non-PVC* Ultra™ Small Bore Extension* Removable Slide Clamp* Male Luer Lock

6 inch PVC pressure monitoring tubing with male/female Luer lock, FDA cleared.

CLAVE® access device includes spike. California Proposition 65 Warning: ⚠ WARNING: These products can expose you to chemicals such as vinyl chloride, ethylene oxide, bisphenol-A (BPA), diisodecyl phthalate (DIDP), and/or di(2-ethylhexyl) phthalate (DEHP) which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov. The above warning is required under California® Safe Drinking Water and Toxic Enforcement Act of 1986, more commonly known as “Prop 65”. Some ICU products may be sterilized using ethylene oxide and some ICU intravenous tubing and drip chambers are manufactured using polyvinyl chloride (PVC) that may contain vinyl chloride, DIDP and/or DEHP. Also, certain manifold, stopcock, connector, and check valve products are manufactured using polycarbonates that may contain BPA. This shipment may contain one or more of these products.

* Standard Bore Extension Set * Removable Slide Clamp * Male Luer Lock * Non-DEHP Formulation * Latex-Free * Sterile * Priming Value: 4.0 mL * Overall Length: 34” (86 cm)

Clear-Cuff® pressure infuser offers many advantages:Product Features:* Thick and durable polyurethane construction provides good visibility of the fluid bag and fluid level* Clear-Cuff® Pressure Infuser can be thoroughly cleaned and reused if desired (Cleaning the Clear-Cuff® Pressure Infuser should be done according to the Instructions for Use) * Built-in hook allows the fluid bag to be replaced without removing Clear-Cuff® from the IV pole* Consistent Fluid Flow - For effective fluid management* Extra large squeeze bulb provides for fast inflation of the infuser. The Hi-Flow™ venting stopcock allows Clear-Cuff® to be deflated almost instantly without squeezing the Clear-Cuff® bag.

MiniLoop™ Extension Set features include:* Small Bore* Sterile* Approx Priming Volume – 0.3 ml* 4-inches

Small Body Stopcocks

4-Way Stopcock features include:* Small Bore* Swivel Male Luer Lock* Lipid Resistant* Sterile

This IV administration set features: * 125 inch length, 15 drop * BCV-CLAVE® * CLAVE® * 2 Gang 1o2® manifold (green,yellow) * Check valve * Rotating luer * Drop-in 3 inch smallbore extension * Non-DEHP tubing California Proposition 65 Warning: ⚠ WARNING: These products can expose you to chemicals such as vinyl chloride, ethylene oxide, bisphenol-A (BPA), diisodecyl phthalate (DIDP), and/or di(2-ethylhexyl) phthalate (DEHP) which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov. The above warning is required under California® Safe Drinking Water and Toxic Enforcement Act of 1986, more commonly known as “Prop 65”. Some ICU products may be sterilized using ethylene oxide and some ICU intravenous tubing and drip chambers are manufactured using polyvinyl chloride (PVC) that may contain vinyl chloride, DIDP and/or DEHP. Also, certain manifold, stopcock, connector, and check valve products are manufactured using polycarbonates that may contain BPA. This shipment may contain one or more of these products.

PROTECTIV® Safety I.V. Catheter offers distinct product safety features, with documented results that prove its success in reducing accidental needlesticks. Most importantly, the choice of catheter materials, FEP polymer and radiopaque polyurethane, and needlepoint design of the PROTECTIV® Safety I.V. Catheter eases conversion to safety.Features: * Compatible with customary technique* Documented results proven to reduce accidental needlesticks* Universal color coded to indicate catheter gauge at a glance

A low-cost IV system designed for 24-hour use that provides protection from accidental needlestick injuries and an effective barrier against microbial contamination. California Proposition 65 Warning: ⚠ WARNING: These products can expose you to chemicals such as vinyl chloride, ethylene oxide, bisphenol-A (BPA), diisodecyl phthalate (DIDP), and/or di(2-ethylhexyl) phthalate (DEHP) which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov. The above warning is required under California’s Safe Drinking Water and Toxic Enforcement Act of 1986, more commonly known as “Prop 65”. Some ICU products may be sterilized using ethylene oxide and some ICU intravenous tubing and drip chambers are manufactured using polyvinyl chloride (PVC) that may contain vinyl chloride, DIDP and/or DEHP. Also, certain manifold, stopcock, connector, and check valve products are manufactured using polycarbonates that may contain BPA. This shipment may contain one or more of these products.

C-Fusor® Pressure Infusers crystal-clear material allows for maximum visibility of fluid levels. It is uniquely designed for rapid fluid set-up and replacement.Product Features:* Secure fastening* Accurate and easy to read pressure Gauge* Durable and easy to clean* Large squeeze bulb for rapid and reliable pressure control* Allows for even pressure around the fluid container* Three way stopcock prevents air leaks

Standard Bore Extension Set with Male Luer Lock * Non-DEHP Formulation * Latex-Free * Priming Vol.: 3.9 mL

Portex® Nylon Epidural Catheter features include:* For 16 g and 17 g Needle* Closed Ended Multiport* Styleted* Sterile* Single Use

LOCKIT Plus® Epidural Catheter Fixation Device features include:* Transparent locking mechanism maintains catheter patency and permits monitoring of catheter exit site* Foam adhesive pad makes application easy and minimizes patient discomfort* Medical grade adhesive layer avoids skin irritation* Easy-to-peel backing makes application straightforward, even when wearing gloves* Fits through 16G/17G needles