Respirometers

Analog Wright Respirometers feature a push button style ON/OFF and RESET control. The units are designed with case seals and material selections to withstand ETO sterilization only. The respirometers have 22mm Male Inlet and Outlets. * Range: 0-100 liters * Material: Chromed Brass * Analog Dial (separate large and small dials) * Inlet and Outlet sizes: 22 mm Male

Digital Respirometers large LCD readout display eliminates the confusion of reading a mechanical respirometer dial. Flow sensing unit has only one moving part, and is detachable from the control unit for ease of sterilization and cleaning. Unit may be washed, gas sterilized or cold sterilized. Comes ready to use with included 9V battery and one (1) circuit adapter (22 mm FxF). * Range: 0-200 liters * Measurement Type: Air/Gas volume flow * Resolutions: 0.02 liter * Flow Rate: 5 LPM minimum/150 LPM maximum * Accuracy: ±2% at calibration point * Resistance to flow: 2 cm of water at 100 LPM * Inlet and Outlet sizes: 22 mm Male

Respirometer Guard is designed to reduce physical damage due to dropping and abuse. Made out of attractive and durable - latex free Neoprene - that can be reliably sterilized. Shipped as a kit with two (2) case closure O-Rings, and is easily installed.

Replacement flow sensing unit, for digital respirometer. Flow sensing unit only with adapter fitting. For use with Digital Respirometer (07-00-295). Features: * Reusable * Latex-free * 22mm Male Inlet and Outlet * Flow Range: 5-150LPM * Accuracy: +/-2% at calibration point * Rugged and Sterilizable

Replacement control unit designed for electronic digital respirometer. Features: * Range: 0-200 liters * Measurement Type: Air/Gas volume flow * Resolutions: 0.02 liter * Flow Rate: 5 LPM minimum/150 LPM maximum * Accuracy: ±2% at calibration point * Resistance to flow: 2 cm of water at 100 LPM * Inlet and Outlet sizes: 22 mm Male

Mounted on rear of controller, connects to sensing unit. Replacement plug for Digital Respirometer (07-00-295). Features: * Reusable * Latex-free * For use with Digital Respirometer (Item # 07-00-295)

Extended length retractile cable designed for use with electronic digital respirometer.

Pole Clamp for the 00-294 and 00-295 Digital Respirometer. Clamp base attaches to the rear of the Controller using case screws. Allows Sensor to be connected while mounted. 1” max diameter.